Let me know if this helps or if you have other questions. there will be a tube attached to the bottom of the sensor that goes from it to the front of the exhaust manifold on the very front of the passengers side exhaust m. To install, reverse the removal procedure. As far as your exhaust pressure sensor it is located on the front of the engine right by the heater core hose a little to the passengers side of the center of the front of the engine. NOTE: Before installation, lubricate the CMP sensor O-ring seal with clean engine oil. Position aside the radio ignition interference capacitor. There is a long story involved with this truck but in short I need to check the cam timing to verify that before I look to the cam phasers for my problem. LH (left-hand) Camshaft Position (CMP) Sensors 2004 - 2008 Ford F150 - Checking cam timing 5.4 - So I did a search first and could not find much of anything. Material : Motorcraft SAE 5W-20 Premium Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)ĭisconnect the exhaust CMP sensor electrical connector and remove the retainer and the CMP sensor. Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).ĭisconnect the intake CMP sensor electrical connector and remove the retainer and the CMP sensor. RH (right-hand) Camshaft Position (CMP) Sensors NOTE: Removal steps in this procedure may contain installation details. Pictures 3 and 4 correlate with these directions. Here are the directions for removal and replacement. You are looking for numbers 1 and 7 on the legend. The second picture is a legend of the components listed. I have attached a picture to help you locate them. There are two per side, one for the intake cam and the other for the exhaust. The sensors are on the rear of the engine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |